Operating the compressor over an extended period of time will cause the compressor unit to overheat which could lead to fire. Allow the compressor to cool down for 10 minutes after each 10 minutes of continuous operation. For precise pressure specifications, refer to the information supplied with the item to be inflated.
Turn the compressor off after appropriate pressure is reached. Open the thumb latch and remove the valve connector from the valve stem. Check air pressure with a pressure gauge. Note Leave the thumb latch in the open position for storing to relieve pressure on the internal mechanisms.
Remove nozzle adaptor from valve connector and store in storage compartment. Note Leave the thumb latch in the open position for storing to relieve pressure on the internal mechanism.
Connecting to an External Battery You can extend battery operating times by connecting the XPower Powerpack to a larger external battery. Page 36 Connecting to an External Battery 3. Connect the black negative — clamp of the cables to the black negative — terminal of the external battery. Page Maintenance Maintenance Chapter 4 provides information on maintaining your internal battery, recharging options for the internal battery, and replacing user-replaceable parts.
Routine maintenance is required to keep your XPower Powerpack Plus operating properly. Occasionally clean the exterior of the unit with a damp cloth to remove the accumulated dust and dirt. If the XPower Powerpack is completely discharged, a typical recharge may take up to 24 hours. An unregulated output or one that exceeds 15 V DC can damage the battery.
This may lead to accumulations of hydrogen, causing exposure to fire and explosion hazard. You will need to purchase a standard 5. However, when the internal battery reaches the end of its service life, the XPower Powerpack itself is no longer of use.
The internal battery is not designed to be user replaceable. Page Troubleshooting Troubleshooting Troubleshooting will help you identify the common problems than can occur with the XPower Powerpack Plus. Read this chapter before calling Customer Service. The XPower Powerpack does not contain any internal user-serviceable parts and attempting to service the unit yourself could result in electrical shock or burn and will void your warranty.
XPower Powerpack has overheated due to poor ventilation or excessively warm environmental conditions. Run time is XPower Powerpack less than battery is not fully expected. XPower Powerpack battery is almost fully discharged. The light does Light bulb has burnt out. The engine XPower Powerpack being boosted battery is not fully will not start. Page 50 Troubleshooting Reference Table Troubleshooting reference Problem Possible Cause The compressor may have compressor overheated from excessive runs slowly.
Battery voltage is too low. Solution Turn off the compressor and let it cool down. Check the condition of the internal battery. This warranty period lasts for 6 months from the date of purchase at the point of sale to you, the original end user customer.
Page 56 Warranty and Return What does this warranty not cover? This Limited Warranty does not cover normal wear and tear of the product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. This warranty does not apply to and Xantrex will not be responsible for any defect in or damage to: a the product if it has been misused, neglected, improperly installed, physically damaged or altered, either internally or externally, or damaged from improper use or Page Return Material Authorization Policy This warranty will not apply where the product is damaged due to improper packaging.
Post office boxes are not acceptable. Page Out Of Warranty Service Warranty and Return Out of Warranty Service If the warranty period for your XPower Powerpack Plus has expired, if the unit was damaged by misuse or incorrect installation, if other conditions of the warranty have not been met, or if no dated proof of purchase is available, your unit may be serviced or replaced for a flat fee. This manual is also suitable for: Xpower plus.
Print page 1 Print document 58 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Check the State-of-charge to ensure the battery is fully charged. Plug the DC appliance into the DC socket and turn the appliance on if required. Page 43 Required How to Operating the compressor over an extended period of time will cause the compressor unit to overheat, which could lead to fire. Allow the compressor to cool down for 10 minutes after each 10 minutes of continuous operation.
Once the compressor cools down to its normal operating temperature it will automatically turn on again and continue inflating. Page Inflating Tires If the XPower Powerpack shuts off due to an over-temperature condition, turn off the power switch and allow the compressor to cool for 15 minutes before re-starting. Inflating Tires The information in Table is for reference only.
For precise pressure specifications, refer to the information supplied with the article to be inflated. Page Figure Inflating Tires Operation To inflate your vehicle, motorcycle, or bicycle tires: 1. Locate Value Connector. Remove from storage and uncoil hose. Install a nozzle adapter if necessary. Place Valve Connector firmly and completely over valve stem on the tire. Press the Thumb Latch toward the hose until it locks into place. Page Inflating Small Sports Equipment Inflating Small Sports Equipment You can use the compressor to inflate small sports equipment such as balls soccer balls and footballs.
When turned on, the radio draws 30 mA, allowing you to use the radio for more than one month when the XPower Powerpack R is fully charged. Condition Listen to the radio Set the clock Turn off the radio to show the time. Set the alarm Turn off the radio to show the time.
Use the Set the alarm clock alarm, turn off radio to show time. For example, an external 60 Ah battery gives approximately four times the operating time of the XPower Powerpack internal 20 Ah battery. Page Maintenance Maintenance Chapter 4 provides information on maintaining your internal battery, recharging options for the internal battery, and replacing user-replaceable parts. Routine maintenance is required to keep your XPower Powerpack operating properly. Occasionally clean the exterior of the unit with a damp cloth to remove the accumulated dust and dirt.
Page Obtaining A Replacement Battery Obtaining a Replacement Battery When the battery reaches the end of its service life, you may purchase a replacement through an industrial battery supplier. The supplier should specialize in deep-cycle batteries. The recommended replacement batteries are standard sizes used for a variety of applications not just the Powerpack , so you may rest assured that the battery will continue to be widely available many years into the future.
Page Replacing The Incandescent Light 4. After removing the old battery, position the new battery close to the back of the XPower Powerpack. However, when the internal battery reaches the end of its service life, you will need to replace it as described in your manual. Because the internal battery contains lead, which can be hazardous if exposed to the environment, the old internal battery should be recycled or safely disposed of at your local recycling depot.
Page 66 Maintenance XPower Powerpack Plus 8" Page Troubleshooting Troubleshooting Troubleshooting will help you identify the common problems than can occur with the XPower Powerpack. Read this chapter before calling Customer Service. The XPower Powerpack does not contain any internal user-serviceable parts and attempting to service the unit yourself could result in electrical shock or burn.
Page 73 Table Troubleshooting reference Problem Possible Cause Over- Inverter has temperature overheated due to poor shutdown ventilation or excessively warm environmental conditions. Alarm sounds Internal battery is nearly discharged. If you ignore this warning, the XPower Powerpack automatically switches off when the battery reaches AC appliance power consumption is higher than expected.
The light does Light bulb has burnt not turn on. This warranty period lasts for 6 months from the date of purchase at the point of sale to you, the original end user customer. Page 78 Warranty and Return What does this warranty not cover? This Limited Warranty does not cover normal wear and tear of the product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems.
This warranty does not apply to and Xantrex will not be responsible for any defect in or damage to: a the product if it has been misused, neglected, improperly installed, physically damaged or altered, either internally or externally, or damaged from improper use or Page Return Material Authorization Policy Exclusions If this product is a consumer product, federal law does not allow an exclusion of implied warranties.
To the extent you are entitled to implied warranties under federal law, to the extent permitted by applicable law they are limited to the duration of this Limited Warranty. Some states and provinces do not allow limitations or exclusions on implied warranties or on the duration of an implied warranty or on the limitation or exclusion of incidental or consequential damages, so the above limitation s or exclusion s may not apply to you.
Page Out Of Warranty Service This warranty will not apply where the product is damaged due to improper packaging. Post office boxes are not acceptable. Page 82 WA Print page 1 Print document 82 pages. Rename the bookmark.
0コメント